BMW X5: Danger Of Poisoning If Oil Is Ingested/Absorbed Through The Skin
Danger of poisoning!
Ingesting oil or absorbing through the skin may cause poisoning!
Possible symptoms are:
- Headaches
- Dizziness
- Stomach aches
- Vomiting
- Diarrhoea
- Cramps/fits
- Unconsciousness
Protective measures/rules of conduct:
- Pour oil only into appropriately marked containers
- Do not pour oil into drinking vessels (drinks bottles, glasses, cups or
mugs)
- Observe country-specific safety regulations
First aid measures:
- Do not induce vomiting.
If the person affected is still conscious, he/she must rinse out their mouth
with water, drink plenty of
water and consult a doctor immediately.
If the person affected is unconscious, do not administer anything by mouth,
place the person in the
recovery position and seek immediate medical attention.
RISK OF INJURY IF OIL COMES INTO CONTACT WITH EYES AND SKIN
Danger of injury!
Contact with eyes or skin may result in injury!
Possible symptoms are:
- Impaired sight
- Irritation of the eyes
- Reddening of the skin
- Rough and cracked skin
Protective measures/rules of conduct:
- Wear protective goggles
- Wear oil-resistant protective gloves
- Observe country-specific safety regulations
First aid measures:
- Eye contact: Rinse eyes immediately with plenty of water for at least 15
minutes; if available, use an eye-rinsing
bottle. If irritation of the eyes persists, consult a doctor.
- Skin contact: Wash off with soap and water immediately. If irritation
persists, consult a doctor.
NOTE: Do not use solvents/thinners.
SAFETY INSTRUCTIONS FOR HANDLING OIL
WARNING: Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Recycling:
Observe country-specific waste-disposal regulations.
Measures if oil is unintentionally released:
- Personal precautionary measures: Danger of slipping! Keep non-involved
persons away from the work
area. Wear personal protective clothing/equipment.
- Environmental protection measures: Prevent oil from draining into drain
channels, sewerage systems,
pits, cellars, water and the ground.
- Limiting spread: Use oil blocks to prevent the surface spread of oil.
- Cleaning procedure: Bind and dispose of escaped oil with nonflammable
absorbents.
NOTE: Do not flush oil away with water or aqueous cleaning agents.
READ NEXT:
IMPORTANT: Use only the approved transmission fluid.
Failure to comply with this requirement will result in serious damage
to the
automatic transmission!
Installation:
Tighten down filler plug using
Special tools required:
00 2 030
23 0 132
23 4 050
NOTE:
The universal transmission bracket is introduced for the E60 AWD
Suitable for manual and automatic transmissions
IMPORTANT: Front and
Special tools required:
00 2 030
23 0 132
23 4 050
24 1 110
24 2 390
24 4 160
23 4 161
24 4 165
IMPORTANT: After completion of work, check transmission oil level.
Use only the approved tra
SEE MORE:
Fig. 1: Identifying 8-Cylinder Spark-Ignition Engine N62TU E60, E61, E63,
E64, E65, E66, E70
INTRODUCTION
The N62TU is an advanced development of the N62.
> N62TU
The 8-cylinder spark-ignition engine N62TU has been modified. Compared to
the N62, the engine
develops more output and torque.
Special tools required:
33 5 120
33 5 122
33 5 125
33 5 200
33 5 206
WARNING: Danger of injury!
Rear differential must be lashed with tightening strap 33 5 206 to prevent
it falling out when the output shafts are forced off.
Necessary preliminary tasks:
Remove propeller shaft on rear differ