BMW X5: LATCH child seat mountings
General information
LATCH: Lower Anchors and Tether for Children.
Pay attention to the specifications and the operating and safety information from the child restraint system manufacturer when selecting, installing, and using LATCH child restraint fixing systems.
Mounts for the lower LATCH anchors
General information
The lower anchors may be used to attach the CRS to the vehicle seat up to a combined child and CRS weight of 65 lbs/30 kg when the child is restrained by the internal harnesses.
Safety information
Warning
If the LATCH child restraint fixing systems are not correctly engaged, the protective effect of the LATCH child restraint fixing system is limited.
There is a risk of injury or danger to life.
Make sure that the lower mountings are securely engaged and that the LATCH child restraint fixing system fits securely against the backrest.
Warning
The attachment points for child restraint systems in the vehicle are intended for attaching child restraint systems only. When other objects are mounted, the attachment points can be damaged. There is a risk of injury or risk of damage to property. Attach only child restraint systems at the corresponding attachment points.
Position
.png)
The corresponding icon shows
the mounts for the lower
LATCH anchors.
Seats equipped with lower mountings are marked with a pair, (2), of LATCH symbols.
For vehicles equipped with a middle seat: It is not recommended to use the inner lower mountings of standard outer LATCH positions to fasten a child restraint system on the middle seat. Use the vehicle safety belt instead for the middle seat.
Before installing LATCH child restraint fixing systems
Pull the safety belt away from the area of the child seat mountings.
Assembly of LATCH child restraint fixing systems
1. Install child restraint system, see manufacturer's information.
2. Ensure that both LATCH anchors are properly engaged.
READ NEXT:
Child restraint systems
with tether strap
Safety information
Warning
If the upper retaining strap is incorrectly used
for the child restraint system, the protective effect
is reduced. There is a risk of injury. Make
sure that the upper retain
Start/Stop button
Principle
Pressing the Start/Stop button
switches drive-ready state on or
off.
Drive readiness is switched on
when you depress the brake
pedal while pressing the Start/Stop button.
Pressing the Star
SEE MORE:
Pressing Output Shaft Out Of Drive Flange (Wheel Hub) And Drawing In
Special tools required:
33 2 111
33 2 115
33 2 116
33 2 117
33 2 118
33 2 160
33 2 201
33 2 202
33 2 203
33 2 205
33 2 207
33 2 208
33 5 070
WARNING: Risk of injury!
It is not permitted to use the impact screwdriver to press out and draw in
the output shaft.
IMPORTANT: Risk of damage!
Replacing Rubber Mounts For Front Axle Carrier In Both Lower Control
Arms
Special tools required:
31 4 151
31 4 152
31 4 153
IMPORTANT: For reasons of driving dynamics, the rubber mounts may only
be replaced in
pairs (refers to left and right control arms)!
Necessary preliminary tasks:
Check ball joint of both control arms while installed, replace lower
control
