BMW X5 Owners & Service Manuals

BMW X5: Pathway lighting

Principle

For the illumination of the vehicle's surroundings after exiting the vehicle, the exterior lighting can be switched on for a defined period of time.

Switching pathway lighting on

After switching off the drive-ready state, briefly push the turn signal lever forward.

Setting the duration

1. "CAR".

2. "Settings".

3. "Exterior lighting".

4. "Pathway lighting".

5. Select the desired setting.

6. "OK".

Daytime driving lights

General information

The daytime driving lights light up when drive-ready state is switched on.

Activate/deactivate daytime driving lights

In some countries, daytime driving lights are mandatory, so it may not be possible to deactivate the daytime driving lights in front.

1. "CAR".

2. "Settings".

3. "Exterior lighting".

4. Depending on country specifications: "Daytime driving lights" or "Daytime driving lights, rear"

Adaptive light functions

Principle

Adaptive light functions enable dynamic illumination of the road.

General information

The adaptive light functions may consist of one system or multiple systems, depending on the equipment version:

Activating

Press the button on the light switch element.

The LED in the button lights up.

The adaptive light functions are active when the drive-ready state is switched on.

Adaptive Light Control

General information

Depending on the steering angle and other parameters, the light from the headlight follows the course of the road.

To avoid blinding oncoming traffic, the Adaptive Light Control does not swivel to the opposite lane when the vehicle is at a standstill.

Cornering light

Principle

In tight curves, for instance on mountainous roads or when turning, an additional, cornering light is switched on that lights up the inside of the curve when the vehicle is moving below a certain speed.

General information

The cornering light is automatically switched on depending on the steering angle or, where applicable, the use of turn signals.

When driving in reverse, the cornering lights may be automatically switched on regardless of the steering angle.

Adaptive headlight range control

The adaptive headlight range control feature balances out acceleration and braking processes as well as the vehicle load conditions in order to avoid blinding oncoming traffic.

READ NEXT:

 Automatic High Beam Assistant

Principle The Automatic High Beam Assistant detects other road users early on and automatically switches the high beams on or off depending on the traffic situation. General information The Automatic

 Interior lighting

General information Depending on the equipment version, interior lights, footwell lights, entry lights, ambient lighting, and speaker lighting are automatically controlled. Overview Buttons in the veh

 Safety

SEE MORE:

 Engine Wiring Loom

REPLACING WIRING HARNESS SECTION FOR ENGINE (N52K) Special tools required: 24 2 390. IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection)! Necessary preliminary tasks: Read out DME fault memory Switch off ignition Disconnect battery negative lead

 Emission Control, Oxygen

REPLACING LEFT OXYGEN CONTROL SENSOR (N62/N62TU) Special tools required: 11 7 030 11 9 150 (cylinder bank 5 to 8) Necessary preliminary tasks: Switch off ignition Remove reinforcement plate WARNING: Scalding hazard! Only perform this task on an engine that has cooled down. Unlock and detach

© 2019-2024 Copyright www.bmwx5info.com