BMW X5: Fuel Transfer, Sensor
BMW X5 (G05) 2019-2026 Service & Repair Manual / Engine / Fuel Supply System / Fuel Transfer, Sensor
- Checking Repumping Function Of Suction - Jet Pump With BMW Diagnosis System
- Removing And Installing/Replacing Carbon Canister
READ NEXT:
Checking Repumping Function Of Suction - Jet Pump With BMW
Diagnosis System
IMPORTANT: Ensure adequate ventilation in the place of work!
Ensure absolute cleanliness when working on the open fuel tank.
Contaminants in the fuel tank can impair driving operation or may even res
Removing And Installing/Replacing Carbon Canister
Necessary preliminary tasks:
Remove rear right wheel arch trim.
Unlock quick-release fasteners (1) and disconnect vent lines.
Release screws (2) and remove carbon canister (3).
Installation:
Tight
Fuel Ventilation
REMOVING AND INSTALLING/REPLACING TANK LEAK DIAGNOSIS MODULE
(PETROL/GASOLINE CARS WITH US DMTL VERSION)
Necessary preliminary tasks:
Remove carbon canister.
Unlock and disconnect quick-connect cou
SEE MORE:
Removing And Installing/Replacing Inlet Camshaft (N52K)
Special tools required:
11 4 281
11 4 481
IMPORTANT: Aluminium screws/bolts must be replaced each time they
are released.
The end faces of aluminium screws/bolts are painted blue for the purposes of
reliable identification.
Jointing torque and angle of rotation must be observed without fail (
Replacing Radial Shaft Seal For Drive Flange (ATC 700)
Special tools required:
23 0 490
27 1 460 DRIFT
IMPORTANT: After completing work, check gear oil level, see
Replenishing /Changing
Transfer Case Oil (ATC 700) and top up if necessary.
Use only approved gear oil in this transfer box.
Necessary preliminary tasks:
Remove transfer box
Drive a h
© 2019-2026 Copyright www.bmwx5info.com
