BMW X5: Fog Lights, Auxiliary
BMW X5 (G05) 2019-2025 Service & Repair Manual / Lights / Fog Lights, Auxiliary
REMOVING AND INSTALLING/REPLACING LEFT FRONT FOG LAMP
Necessary preliminary tasks:
- Remove left grille in bumper trim.
Grasp grille through opening.
Disconnect plug connection (1).
Release screws (2).
Slide fog light (3) slightly towards center of vehicle and remove towards rear.
Fig. 20: Identifying Plug Connection, Fog Light With Screws
Replacement:
- If necessary, remove bulb.
- Adjust fog lamps.
REMOVING AND INSTALLING/REPLACING RIGHT FRONT FOG LAMP
Operation is described in:
Removing and installing left front fog lamp.
READ NEXT:
Rear Light Cluster
REPLACING SOCKET HOUSING FOR LEFT OR RIGHT REAR LIGHT
WARNING: Follow instructions for handling light bulbs (exterior
lights).
Rear light in side panel:
Remove flap in luggage compartment trim panel.
Brake Lights
REMOVING AND INSTALLING/REPLACING AUXILIARY BRAKE LIGHT
Necessary preliminary tasks:
Remove rear spoiler.
Release screws (1).
Lift auxiliary brake light (2) in direction of arrow from rear spoiler
License Plate Lights
REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT NUMBER/LICENSE
PLATE LIGHT
Special tools required:
64 1 020.
WARNING: Follow instructions for handling light bulbs (exterior
lights).
Lever license
SEE MORE:
Adjusting Camshaft Timing On Right Side (N62/N62TU)
Special tools required:
11 9 190
11 9 460
11 9 461
11 9 462
11 9 463
(cylinder bank 1 to 4)
Necessary preliminary tasks:
Are described in the operation "CHECKING CAMSHAFT TIMING ON RIGHT SIDE".
Remove right timing case cover.
NOTE: When slackening screws, grip camshafts at hexagon head.
S
Carrying Out Ride-Height-Calibration
NOTE: Ride-height-calibration must be carried out after the following
work:
Removal/replacement of ride-height sensor or its control rod
Replacement of wiring harness
Replacement of air supply unit control unit
Replacement of Vertical Dynamics Management control unit
Connect BMW diagnosis sys
© 2019-2025 Copyright www.bmwx5info.com
