BMW X5: Coolant Checking Cooler Line
BMW X5 (G05) 2019-2026 Service & Repair Manual / Cooling System / Coolant Checking Cooler Line
- Checking And If Necessary Correcting Oil Cooler Line (N52K)
- Instructions For Working On Cooling System
- Draining And Adding Coolant In Radiator (N52K)
READ NEXT:
Checking And If Necessary Correcting Oil Cooler Line (N52K)
IMPORTANT: Danger of scalding! Only perform this work after engine has
cooled down.
Necessary preliminary tasks:
Remove underbody protection.
Recycling
Transmission fluid emerges when oil lines ar
Instructions For Working On Cooling System
WARNING: Danger of scalding! Work on the cooling system should only be
carried
out when the engine has cooled down.
IMPORTANT: Wear protective gloves and goggles.
IMPORTANT: Lifetime coolant filling:
Draining And Adding Coolant In Radiator (N52K)
WARNING: Danger of scalding!
These tasks on the cooling system should only be carried out on an
engine that has cooled down!
IMPORTANT: Wear protective gloves and goggles.
IMPORTANT: Lifetime coolant
SEE MORE:
Replacing Level Switch For Dynamic Drive Fluid Reservoir
Unscrew nuts.
Remove shims.
Installation:
Replace self-locking nuts.
Fig. 162: Locating Nuts
NOTE: Raise and/or turn fluid reservoir in order to gain better access
to plug
connection.
Disconnect plug connection (1).
Turn level switch (2) through approx. 45º and remove towards bottom.
Fig. 163:
Removing And Installing Outer Upper Rail Trim With Electric Anchor Fitting
Tensioner (From 04/2004)
Driver's seat only:
NOTE: Version with anchor fitting tensioner from 04/2004.
Lever trim (3) out of seat mechanism:
upwards,
slide towards rear
and feed out of anchor fitting tensioner.
Installation:
Secure plug connection with felt strip against unlocking.
Lock on plug connection to anchor fit
© 2019-2026 Copyright www.bmwx5info.com
