BMW X5: Propeller Shaft Assembly
BMW X5 (G05) 2019-2026 Service & Repair Manual / Propeller Shaft / Propeller Shaft Assembly
- Overview (Inserted Propeller Shaft)
- Replacing Centre Mount Gaiter
- Removing And Installing/Replacing Centering Mount For Propeller Shaft
READ NEXT:
Overview (Inserted Propeller Shaft)
Fig. 1: Overview Of Inserted Propeller Shaft
Complete propeller shaft
Flexible disc
Centering mount
Centre mount
REMOVING AND INSTALLING PROPELLER SHAFT (INSERTED) COMPLETELY
Special tools requ
Replacing Centre Mount Gaiter
Necessary preliminary tasks:
Remove propeller shaft.
NOTE: The propeller shaft is balanced. The front and rear propeller
shafts must be
reassembled in the same position.
Detach gaiter (1) from gr
Removing And Installing/Replacing Centering Mount For Propeller
Shaft
Special tools required:
00 5 500 00 5 500 HANDLE FOR DRIFTS
11 1 310 11 1 310 DRIFT
11 2 030 11 2 030 DRIFT
Necessary preliminary tasks:
Remove propeller shaft.
Fill centering bore (1) complet
SEE MORE:
Checking And If Necessary Correcting Oil Cooler Line (N52K)
IMPORTANT: Danger of scalding! Only perform this work after engine has
cooled down.
Necessary preliminary tasks:
Remove underbody protection.
Recycling
Transmission fluid emerges when oil lines are detached from heat exchanger.
Catch and dispose of escaping transmission fluid.
Observe country-
Removing And Installing/Replacing Rocker Arms On Left Inlet Side (N62
From 9/03 And N62TU)
Special tools required:
11 9 470
11 9 473
(cylinder bank 5 to 8)
Removal of rocker arms is described separately from installation.
Necessary preliminary tasks:
Remove servomotor for left eccentric shaft.
Remove ignition coils on cylinder bank 5 to 8.
Remove left cylinder head cover.
Remove
© 2019-2026 Copyright www.bmwx5info.com
