BMW X5 Owners & Service Manuals

BMW X5: Mount Securing Fixture For Vehicle On Lifting Platform

BMW X5 (G05) 2019-2024 Service & Repair Manual / Front Axle / General / Mount Securing Fixture For Vehicle On Lifting Platform

Special tools required:

WARNING: Danger to life! Mount securing fixture for vehicle on lifting platform to prevent the vehicle from slipping off or tilting down.

WARNING: Observe the following directions and instructions when handling the special tool:

  1. Prior to each use, check the special tools for defects, modifications and operational reliability.
  2. Damaged/modified special tools must not be used!
  3. No changes or modifications may be made to the special tools!
  4. Keep special tools dry, clean and free of grease.
  5. Impact screwdrivers may not be used!

IMPORTANT: Risk of corrosion! Touch up paintwork damage.

Re-establish wax layer.

Remove vehicle jack fixture with a suitable tool from side frame.

Installation:

Check fixture for damage, replace if necessary.

Front Axle
Fig. 12: Identifying Vehicle Jack Fixture

NOTE: Following states can be selected on special tool 00 2 261.

  1. Vehicle unsecured
  2. Vehicle secured (after special tool is lashed to lifting platform arm)

Front Axle
Fig. 13: Identifying Special Tool (00 2 261)

NOTE: The following procedure must always be carried out on the left and right sides.

Insert special tool 00 2 261 into opening in side frame with 3/8" extension and secure ratchet to body. To do so, turn lock through 90º up to stop.

WARNING: Danger to life!

Check stopping of special tool 00 2 261 on side frame, correct attachment if necessary.

Front Axle
Fig. 14: Identifying Special Tool (00 2 261)

Lash special tool 00 2 261 with tensioning strap 00 2 262 crosswise (as pictured) to lifting platform arm.

WARNING: Danger to life! Carry out tensile and visual inspection of tensioning strap 00 2 262 , correct position if necessary.

Front Axle
Fig. 15: Identifying Special Tool (00 2 262)

READ NEXT:

 Front Axle Suspension

REMOVING AND INSTALLING/REPLACING REINFORCEMENT PLATE IMPORTANT: Observe safety when raising the vehicle. Driving without reinforcement plate is not permitted! Release bolts (1) for assembly undersid

 Front Sub-Frame

 Replacing Front Axle Carrier

WARNING: Danger to life! Mount securing fixture for vehicle on lifting platform to prevent the vehicle from slipping off or tilting down. Secure engine in installation position to prevent it from fal

SEE MORE:

 Depending on the equipment version: lane change with active guidance

Principle The system assists the driver when lane changes are necessary to reach a navigation destination. General information The system uses the sensors of the steering and lane control assistant. Safety information Warning The system cannot serve as a substitute for the driver's personal judgment

 Control Unit Box

REMOVING AND INSTALLING/REPLACING ELECTRONICS BOX IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION). NOTE: Follow instructions for removing and installing electronic control units. Necessary preliminary tasks: Read fault memory Disconnect negative

© 2019-2024 Copyright www.bmwx5info.com