BMW X5 Owners & Service Manuals

BMW X5: Displays in the instrument cluster - Active Cruise Control with Stop&Go function ACC

BMW X5 (G05) 2019-2024 Owners Manual / Controls / Driver assistance systems / Displays in the instrument cluster - Active Cruise Control with Stop&Go function ACC

Displays in the instrument cluster

General information

Depending on the equipment version, the displays in the instrument cluster may vary.

Display in the speedometer

Depending on the equipment, a mark in the speedometer displays the status of the system.

Distance to vehicle ahead of you

Selected distance to the vehicle ahead of you is shown.

Distance 1

Distance 2

Distance 3

Distance 4

This value is set automatically after the system is switched on.

No distance control display, as the accelerator pedal is being pressed.

Green icon: A vehicle has been detected ahead of you.

When the distance to the detected vehicle increases, the vehicle symbol in the distance display will move away.

If necessary, independent drive-off, such as by stepping on the accelerator pedal or by pressing the rocker switch.

Indicator/warning lights

Vehicle symbol white: No distance control display, as the accelerator pedal is being pressed.

Green icon: A vehicle has been detected ahead of you.

The vehicle symbol goes out if no vehicle in front is detected.

Vehicle symbol flashes green: Vehicle in front drove off.

Gray icon: System interrupted.

Symbol flashes gray: The conditions are not adequate for the system to work.

The system was deactivated but applies the brakes until you actively resume control by pressing on the brake pedal or accelerator pedal.

Vehicle symbol flashes red and a signal sounds: Brake and make an evasive maneuver, if necessary.

Alternative displays

Indicator light green: system is active.

No indicator light: system is switched off.

Vehicle symbol flashes: The conditions are not adequate for the system to work.

The system was deactivated but applies the brakes until you actively resume control by pressing on the brake pedal or accelerator pedal.

The vehicle symbol and distance bars blink red and an acoustic signal sounds: Brake and make an evasive maneuver, if necessary.

System interrupted.

Displays in the Head-up Display

Set speed

Some system information can also be displayed in the Head-up Display.

The icon is displayed when the set speed is reached.

Distance information

The icon is displayed when the distance from the vehicle traveling ahead is too short.

The distance information is active in the following situations:

READ NEXT:

 System limits - Active Cruise Control with Stop&Go function ACC

System limits System limits of the sensors Additional information: Cameras Radar sensors Detection range The detection capability of the system and the automatic braking performance are limited.

 Speed Limit Assistant

Principle Speed Limit Assistant supports driving at the speed limit. A suggested speed can be applied. General information When the systems in the vehicle, e.g., Speed Limit Info, detect a change of t

 Steering Assistant

Principle The Steering Assistant helps keep the vehicle in the lane. For this purpose, the system executes supporting steering movements, for instance when driving in a curve. General information Depe

SEE MORE:

 Ignition System Diagnosis

The ignition system on modern BMW engines consist of one ignition coil per cylinder. This arrangement is known as RZV, or Direct Stationary Ignition. The ignition coil receives fused power usually from the DME main relay or IVM (N62). The ignition coil primary circuit is controlled (triggered) by

 Maintenance

BMW maintenance system The maintenance system provides service notifications and thereby provides support in maintaining road safety and the operational reliability of the vehicle. In some cases, scopes and intervals of the maintenance system may vary according to the country version. Replacement w

© 2019-2024 Copyright www.bmwx5info.com