BMW X5: Control Display
Brightness
1. "CAR".
2. "Settings".
3. "Displays".
4. "Control display".
5. "Brightness at night".
6. Press the Controller.
7. Turn the Controller until the desired brightness is set.
8. Press the Controller.
Depending on the light conditions, the brightness settings may not be clearly visible.
Reset vehicle data
All individual settings can be reset to the factory settings when the drive-ready state is switched off.
1. "CAR".
2. "Settings".
3. "General settings".
4. "Reset vehicle data".
5. "Reset vehicle data".
When the stored settings in a driver profile are synchronized with the ConnectedDrive account, these settings will remain in the ConnectedDrive account.
READ NEXT:
Notifications
Principle
The menu centrally displays all notifications arriving
in the vehicle in form of a list.
General information
The following notifications can be displayed:
Traffic messages.
Check Control
Data protection
Data transmission
Principle
The vehicle offers different services, whose use
requires a data transfer to BMW or a service provider.
The data transmission can be deactivated
for some services.
General
SEE MORE:
Oil Pump With Filter
REMOVING AND INSTALLING/REPLACING OIL PUMP (N62)
Necessary preliminary tasks:
Drain engine oil.
Remove upper oil sump section.
Remove reinforcement plate.
Unscrew nut (1).
Tightening torque 11 41 4AZ.
Remove oil pump sprocket wheel (2).
Fig. 709: Identifying Oil Pump Sprocket Wheel
Release
Initializing Rain/Light Sensor
NOTE: Initialization is necessary:
After replacing windshield
When installing a used rain/light sensor
NOTE:
Connect BMW diagnosis system
Initialize rain/light sensor.
REPLACING OPTICAL ELEMENT FOR SOLAR RAIN/LIGHT SENSOR
IMPORTANT: Read and comply with notes on protection against
electros
© 2019-2026 Copyright www.bmwx5info.com
