BMW X5 Owners & Service Manuals

BMW X5: BMW Accident Assistance

Principle

BMW Group Accident Assistance can be contacted if assistance is needed in the event of an accident.

General information

If the vehicle sensors detect a minor to moderately severe accident, which did not trigger any airbags, a Check Control message appears on the instrument cluster. In addition, a text message appears on the Control Display.

When BMW Accident Assistance is activated, data on the vehicle's condition is sent to BMW.

Functional requirements

Starting BMW Accident Assistance

If an accident is detected automatically

A text message relating to BMW Accident Assistance appears on the Control Display.

The connection can be established directly: "Contact accident assistance" The Check Control message for BMW Accident Assistance can also be called up from the stored Check Control messages for a certain length of time.

Starting manually

BMW Accident Assistance can also be contacted independently of the automatic accident detection function.

1. "APPS".

2. "Installed apps".

3. "BMW Assist".

4. "BMW Accident Assistance".

Follow the displays on the Control Display. A voice connection is established.

READ NEXT:

 Emergency Call

Intelligent emergency call Principle In case of an emergency, an emergency call can be triggered automatically by the system or manually. General information Only press the SOS button in an emergency.

 Jump-starting

General information If the battery is discharged, the engine can be started using the battery of another vehicle and two jumper cables. Only use jumper cables with fully insulated clamp handles. Safet

 Tow-starting and towing

Safety information Warning Due to system limits, individual functions can malfunction during tow-starting/towing with the Intelligent Safety systems activated. There is a risk of accident. Switch all

SEE MORE:

 Removing And Installing Rear Cabin Monitor (Complete)

Necessary preliminary tasks: Remove fresh-air grille in rear cabin. Remove trim from rear cabin monitor base at front. Release screws (1) and remove rear cabin monitor with holder (2). Disconnect associated plug connections and feed out leads. Tightening torque. Fig. 39: Identifying Rear Ca

 Replacing Centre Mount Gaiter

Necessary preliminary tasks: Remove propeller shaft. NOTE: The propeller shaft is balanced. The front and rear propeller shafts must be reassembled in the same position. Detach gaiter (1) from groove (2). Mark front propeller shaft (3) and rear propeller shaft (4) in one plane. Fig. 13: Identi

© 2019-2025 Copyright www.bmwx5info.com